Wiring Solenoid Valve to water Level Switch?
I have a solenoid valve just like this
its rated 120 VAC/26VA (3 prongs, one for ground) . I also have a
horizontal level switch for liquid like this 
with
rating 120 VAC/0.28 A (the switch will connect when the water level
reach the target) normally open.
How can I wire them so that when the level reached the valve will
close and water will not flow into the tank? The switch is inside the
tank and the valve connecting the pipe for feed water. The Shocker used two control valves electro-magnet to obtain separate
controls on the ball loading sequence and the sequence of delivery by
air. The Angel uses a hammer and bolt attached, allowing the use of a
single solenoid to actuate the firing sequence while controlling a
piston fed the hammer bolt / forward at the Gate Valve same time chambering a
paintball and to release the propellant at the end of the stroke of the
hammer.
The device of the double solenoid Shocker allowable
operating pressures slightly less to use, but the arrangement
considerably simpler Angel