Z641H-16P Pneumatic Gate Valve CV Value Parameters and Selection Guide
Understanding its flow coefficient, expressed as CV or KV, is the starting point for correct sizing and reliable operation.The main gate valve product names of China gate valve Network include:API Bellows gate valve,API Manual Lug&wafer Knife-shaped Gate Valve,API Sprocket Lug&wafer Knife-shaped Gate Valve,API Electric Lug&wafer Knife-shaped Gate Valve,API Bevel Gear Lug&wafer Knife-shaped Gate Valve,API Pneumatic Lug&wafer Knife-shaped Gate Valve,API Cryogenic Gate Valve,API Flange Gate Valve.
CV and KV Flow Coefficient Parameters
In Chinese engineering practice, the flow coefficient is commonly expressed as KV, with the relationship KV = 0.865 CV. For the Z641H series gate valve, the published KV values across nominal sizes are as follows: DN40, KV 170; DN50, KV 270; DN80, KV 510; DN100, KV 940; DN125, KV 1400; DN150, KV 2200; DN200, KV 3500; DN250, KV 8500; DN300, KV 9600; DN350, KV 13000; DN400, KV 17000; DN450, KV 55000; DN500, KV 27000; DN600, KV 38000. These values reflect the full-open capacity of the valve and should be used as the basis for line sizing.
Selection Guide
The first step in selection is to calculate the required CV or KV from the design flow rate, allowable pressure drop, and fluid properties. A sound rule is to ensure that the valve‘s full-open CV is at least 1.2 times the calculated value. For pure on-off isolation, a full-bore gate valve is preferred to minimize pressure loss.
The second step is material and pressure matching. The Z641H-16P designation indicates a PN16 stainless steel body, typically available in 304, 316, or 316L, with a temperature range from minus 29 to 550 degrees Celsius depending on trim and packing selection. The valve is suitable for air, water, steam, oil, and mildly corrosive fluids such as nitric and acetic acid.
The third step concerns the actuator. Supply pressure typically ranges from 0.3 to 0.8 MPa, with double-acting units requiring 2 to 8 bar and spring-return units requiring 4 to 8 bar. For fail-safe operation, a spring-return actuator should be specified so that the valve closes or opens on air failure.
Finally, verify the leakage class and sealing performance. The Z641H series is rated for a leakage rate as low as 10⁻⁸ times KV, reflecting a metal-to-metal hard seal suitable for tight shutoff in high-temperature service. For demanding applications, confirming test reports against the relevant design and inspection standards completes a reliable selection.
Do you still need to know or purchase the following gate valve products:



