You are here:
News
News
Depth of water sensing 2010-12-23
I have been thinking pressure sensor but everything I have found is quite expensive packaged sensors.
Any ideas on other ways to monitor depth or sources of something I can use for a sensor in a 500'
Induction Pump Motor Back Spin Protection 2010-12-21
We had a situation recently where a 1000 hp 11.5 kV induction motor (full voltage start) was burned up because someone accidently tried starting the pump while it was spinning backwards.
KSB feed pump balancing disc damage 2010-12-21
Has anyone else experienced this failure and what was the resultant findings?
Double Block and Bleed Valves thread408-48267 2010-12-21
What code is davefitz refering to? I ask this because at our facility we are currently installing a second boiler that will be connected to our existing boiler. I'm not the engineer over this project
2 Functions with single pump? 2010-12-21
I am needing to do the following functions with the avalibility of a single dc motor: evenly lift pair of cylinders with even loads,simultaneously, lift and gravity lower each cylinder independently w
Swing Check Valve 2010-12-20
A supplier brought to my attention that I had an unusually high velocity going through a check valve in a PS design I was working on...
Pressure Operated Pipeline Drain Valve? 2010-12-20
I'm looking for a particular type of valve, and am having a lot of difficulty in doing so...hoping you folks can help.
Swing Check Valve 2010-12-20
We are investigating the use of a swing check valve to control reverse flow at an air compressor inlet. A swing check valve was chosen to minimize flow restriction.
